why Thermo Riko? | THERMO RIKO CO.,LTD.

why our infrared guide heating system is the 1st choice?

Problems of the conventional products

Conventional resistance heating systems raise temperature slowly, requiring a significant amount of time to achieve a high temperature. This limits the number of tests feasible within a day, extending the product development cycle as well.

<Thermo Riko’s Solution>

#1 High Speed, High Temperature

MAX. heating rate 300℃/sec.
Reaching 1,500℃ at Maximum.

Problems of the conventional products

It’s hard to raise temperature of a moving sample with a direct heating system, which may cause damages to the surface of such sample. It could also destroy a sensor touching the surrounding area.

<Thermo Riko’s Solution>

#2 Non-contact heating

Enable to heat the sample without physically contacting it.

Problems of the conventional products

Conventional heating systems raise temperature of a sample itself, and its peripheral temperature as well. There is a risk of damage to a sensor touching the surrounding area.

<Thermo Riko’s Solution>

#3 Pinpoint heating

Heating only the samples
without surroundings.

Problems of the conventional products

Conventional systems, such as electrical resistance heaters, may emit gas pollutive to a sample.

<Thermo Riko’s Solution>

#4 Clean-heating

Eliminating the risk of air pollution.

Problems of the conventional products

Conventional systems only raise temperature from specific angles. This limits the available heating methods.

<Thermo Riko’s Solution>

#5 360° degrees

Infrared beams irradiate the sample
from any angle 360°

Problems of the conventional products

With conventional systems, a heater must be placed inside a vacuum environment. This could contaminate a sample with the emitted gas.

<Thermo Riko’s Solution>

#6 Vacuum atmosphere

Enable to Heat the samples
in a vacuum atmosphere.

Problems of the conventional products

Adding a new heater to an existing system requires a large-scale modification, which may involve a significant cost. Such modification may be simply impossible due to space and/or structural issues.

<Thermo Riko’s Solution>

#7 Easy to add on

Can be attached to your equipment. All you need is only 1 port.

Problems of the conventional products

Conventional systems usually require an electrical power of 10kW. As described above, it also requires a long time to raise temperature of a sample, extending the overall development time and causing more cost. Besides, it usually involves a significant cost to add a new system.

<Thermo Riko’s Solution>

#8 Cost saving

Only 2kw required for operation.
Less investment cost compared to Conventional ones.

learn why these features can be achieved

learn more